Brake Fluid Testing

On 19/09/2021 / By David Jenkins

There are several brake fluid testers on the market, however the most reliable method of determining the efficacy of your brake fluid is to boil it which is exactly what the AutoTest Brake Fluid tester does.

Many brake fluid testers measure just conductivity not boiling point, making it very difficult to determine its efficacy, which is determined by boiling point!

Brake fluid is designed to have a high boiling point, to withstand the high temperatures generated during braking. The one major drawback, due to its chemical composition- it absorbs moisture. This can be moisture from the air (via the breather hole in the master cylinder cap) or via the rubber hosing. The more moisture in the brake fluid, the lower the boiling point. This increases the risk of “brake fade”; under heavy driving conditions, such as towing, or on steep, winding roads or stop-start braking at high speeds, brake fluid boils, turns to vapour, and the brake pedal goes straight to the floor with no braking action. This is known as “vapour-lock”. If the police are called to such an accident, unless they test the boiling point of the brake fluid, all will appear normal: the brake fluid will have cooled back down, the brake pedal will feel firm, and the driver, having previously been unable to stop, will be faced with some serious questions.

Brake fluid is a safety-critical item, but how many drivers know or ever ask to get their brake fluid checked? They know about their oil & windscreen washer fluid, but brake fluid has been largely ignored by both the vehicle manufacturers and garages.

So how do you test for moisture in brake fluid?

The only approved way is to boil it.

On the back of every bottle of brake fluid is a chart showing the “dry” (uncontaminated), and “wet” (contaminated) boiling points of all the various grades of brake fluid. Brake fluid manufacturers use what’s called an ERBP (Equilibrium Reflux Boiling Point) test to determine the boiling point of brake fluid. In a lab this can take hours to set up and complete.

The AutoTest Brake Fluid Tester bringing brake fluid to boiling point during a test.

The AutoTest Brake Fluid tester is designed to test the boiling point of the fluid in the car in less than 30 seconds, with digital accuracy. It works on all grades of brake fluid and shows clearly what the fluid has boiled at, and what the DOT minimums are for each, making the fluid change decision easy for the technician and the customer.

Once the brake fluid has been changed, garages can offer to re-test the brake fluid using the AutoTest Brake fluid tester, to clearly show the improved results on the new fluid. Consumers should also be aware that new brake fluid from a sealed bottle must be used for every brake change. There have been cases where brake fluid has been left in an opened bottle, effectively making the “new” fluid as contaminated as the old.

AutoTest article in Australian Automotive Aftermarket Association Magazine on Brake Fluid Testers

Read the Australian Automotive Aftermarket Association article on the Brake Fluid Tester.

Brake Fluid Test Automotive Garage Tools Roadworthy

Want to know more?

For more information see our Brake Fluid Tester, or contact us directly for a quote.

« »